|
|
Instruction for the Installation of Finger Recognition Device System. (FRD)
1. Download and paste into windowssystem32 the 2 OCX
files... COMDLG32.OCX
MSADODC.OCX
2. Do the same for the eight (8) DLLs...
commpro.dll comms.dll
msvcr71.dll plce.dll
rscagent.dll rscomm.dll
zkemkeeper.dll zkemsdk.dll
3. After this successive downloads, go to "start",
"run" and type in "regsvr32 Zkemkeeper.dll". You
must be able to see a "notification" of successful
installation or registration procedure.
4. Creating the ODBC connection.
a. create a folder named fp4 in the root directory
just by simple "explorer" method.
b. download this two files into fp4 folder
markDemo.exe fpDataEIS.mdb
Note: when you run this markdemo.exe which is
actually the pipe program for the device and
the computer, you may have to check that a
message "on connected" is right on this
program's screen to verify that the connection
has really been established.
The IP-Addresses should be set at the range of
192.168.0.201 for the device
and
192.168.0.### for those PC that needs to be
connected with it
You can however request for other IP settings
from our technical support.
c. click start,
"control panel" tab,
"administrative tools",
"data source ODBC".
At this junction,
click on the "user DSN" tab.
click "Add" and
select "Microsoft Access Driver (*.mdb)",
then click "Finish"
On the "Data Source Name",
type in "gencarFP"
click on the "select" tab.
Then, select the drive of fp4, you will see
the corresponding MDB file, that is,
fpdataEIS.mdb, select it.
Click "OK" until you are finished.
That's all it takes for the "ODBC Connection"
5. The Setup will be complete when you are given the
TimeKeeping Files which is supposed to be "copied"
and "pasted" into a folder named FP3.
Either by purchasing it from our vendors or
Agents, these installation will be available
and ready for use together with our payroll
software. Email us for your requests then. |
